The Maintenance Of The Motor Cable Is Very Important

The driving of the motorcycle is controlled by the cable pull, and the clutch, throttle, choke and front brake cannot be separated from the cable. Therefore, the maintenance of the line is very important. The following are two ways to prevent the cable from being disconnected:

One, often lubricate the cable

Motorcycle pull cords are prone to rust and aging due to the sun and rain, and the infiltration of dust and rain may cause the cord to be pulled inflexibly or even broken. Therefore, often fueling the line is an important item for vehicle maintenance.

This method is very simple. After receiving the car at night, remove the end of the line that needs to be oiled from the front of the car, wrap the outer skin of the line with scotch tape, and then drop a few drops of engine oil into the funnel. Note that the funnel should be vertically upward. ; The next morning you will find that the oil in the funnel is gone, and the lower end of the line has leaked out, which indicates that the oil has penetrated into the inside of the line. This kind of maintenance only needs to be done once a month.

2. Replace faulty lines in time

Some Mo friends found out that a certain cable in their car was broken, but they still used it as usual. They didn't know that this would leave hidden dangers. In case the cable was completely broken on the way, it would be you who would be affected. If the clutch line is broken, it cannot be ignored. If the throttle cable is broken and no fuel can be applied, especially if the throttle cable is broken in the middle part, the throttle will be stuck and cannot be returned, causing "speeding".